Simulator Solutions Showcase
The pictures below show SimStack being used in a number of commercial and private simulators.
For more information about SimStack, please contact us.
SimStacks
A SimStack with DIN Rail mounting brackets installed.
Circuit Breaker Installation
Installing SimStacks into the P6 circuit breaker panel in a 747-400 simulator.
SimStack Way
SimStack & Power Supplies
SimStacks installed behind a P6 panel with Power Supplies and distribution blocks.
Nooks and Crannies
SimStack boards can be discreetly mounted in some tight spaces.
757 Overhead Panel
This single SimStack was installed in the overhead panel of a 757 simulator.
P7 Panel Installation
This installation was performed to allow the SimStacks to be accessible during maintenance.
Ship Simulator Installation
These SimStack boards were installed inside the control cabinet of a ship simulator.
MCDU Project
This SimStack board was mounted inside a 737 MCDU.
SimStacks Inside a Dauphin
This SimStack was installed up near the rotor mast.
Helicopter Simulator - Front
The front view of a Dauphin helicopter simulator.
Wiring Looms
These wiring looms run to the overhead panel, behind the library in a 747-400 simulator.
Completed SimStack
This SimStack and its wiring loom is ready for installation into a simulator.
Stow Before Take-Off
An example of a test harness connected to a SimStack.
Light Bulb Replacement
Replacing light bulbs behind P7 circuit breaker light plates.
Aftermarket MCP
This aftermarket Mode Control Panel was updated to use SimStack.
Mode Control Panel
The SimStacks were retrofitted into this custom build Mode Control Panel.
Customer SimStack Installation
These SimStacks have been installed in a 737 centre pedestal.
Front View
The front view of a customer's 747-400 simulator.
Side View
A side view of power supplies, power distribution and SimStack boards on a 747-400 simulator.
11 SimStacks on a Wall
SimStacks mounted on the side of a 747-400 fuselage, controlling the overhead panels.
Looms
The installation of a series of custom made looms for a 747-400 cockpit conversion project.
AST-300 Installation
Installation of an overhauled AST-300 Synthetic Flight Trainer in Tasmania
Overhauled AST-300 Synthetic Flight Trainer
The AST-300 was equipped with two modern GPS units to replace the aging NAV/COM setup. This made the unit more relevant in the current training environment.
The SimStacks in the AST-300
These four SimStacks replaced the aging 1980's technology that used to drive this AST-300 flight trainer.
AST-300 Instruments
Custom Wiring Solutions
AST-300 Installation
The AST-300 flight trainer was installed with a touch-screen instructor console.
Old School Instrument Flying
Analog instruments in this AST-300 are powered by SimStack to provide a realistic instrument training experience
AST-300 Powered by SimStack
The completed AST-300 Synthetic Flight Trainer, installed in Hobart.